Publicidad
Idiomas disponibles
Idiomas disponibles
WORKING MODE
TRANSFER WORKING MODE
In TRANSFER working mode, both the central brush and the side brushes are in their idle positions. This working
mode is used to transfer the machine from the work site to the maintenance site.
To use the machine in transfer mode, do the following:
1.
Carry out all the checks listed in the
2.
Sit on the driver's seat.
3.
Insert the key (1) into the slot (2) on the right side of the column (Fig.1).
4.
Turn on the machine and turn the key (1) a quarter turn clockwise (Fig.2).
5.
When the control display is turned on, screens appear in sequence, the last of which contains the machine
programming characteristics.
2
1
N.B.: when the machine is turned on, the TRANSFER working mode is enabled.
6.
The machine is now in the transfer working mode.
7.
Press the drive pedal (3) (Fig.3) to begin moving the machine.
3
3
"WORK PREPARATION CHECKLIST" on page
1
2
42
42
39.
1
Publicidad
