Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE SIDE BRUSHES
Thoroughly clean side brushes will ensure a cleaner floor, thereby reducing costs and increasing environmental
sustainability. To clean the side brushes, proceed as follows:
1.
Go to the right-hand side of the machine.
2.
Remove the knob (1) fixing the side brush to the gear motor by rotating the right brush clockwise and the left
brush anti-clockwise (Fig.1)..
3.
Remove the washer (2) holding the side brush in place (Fig.1).
4.
Remove the brush from its support (Fig.3).
2
1
1
5.
Clean the brush under a stream of running water to remove any impurities from its bristles.
N.B.: check the wear of the bristles and replace the brush if they are excessively worn. See
THE SIDE BRUSHES" on page
6.
After cleaning, repeat the operations in reverse order to reassemble all the parts.
7.
Once this brush has been fitted, move on to the left-hand one (if used).
CLEANING THE PANEL FILTER
A thoroughly clean panel filter will ensure better machine vacuum system results, thereby reducing costs and
increasing environmental sustainability. To clean the panel filter, proceed as follows:
1.
Go to the side of the machine.
2.
Grip the handle (1) and turn the upper body (2) to its maintenance position (Fig.1).
3.
Stand at the back of the machine.
4.
Grip the handles (3) and turn the vacuum fan support plate (4) to its maintenance position (Fig.2).
5.
Take the panel filter (5) out of the machine (Fig.3).
1
3
2
74.
2
1
2
3
4
3
69
69
"ASSEMBLING
5
Publicidad
