Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE CENTRAL BRUSH
A thoroughly clean central brush will ensure a cleaner floor, thereby reducing costs and increasing environmental
sustainability. To clean the central brush, proceed as follows:
1.
Open the left inspection door (1) (Fig.1).
2.
Loosen the knobs (2) of the central brush inspection carter (Fig.2).
3.
Loosen the knob (3) of the central brush lifting arm (Fig.3).
1
1
4.
Remove the central brush inspection carter (4) (Fig.4).
5.
Take the brush out of the tunnel in the machine frame (Fig.5).
6.
Clean the brush under a stream of running water to remove any impurities from its bristles.
N.B.: check the wear of the bristles and replace the brush if they are excessively worn (the bristle length
must not be less than 15 mm; this measurement is indicated on the brush by the yellow band). See
"CENTRAL BRUSH REPLACEMENT" on page
7.
After cleaning, repeat the operations in reverse order to reassemble all the parts.
N.B.: when the brush is mounted correctly, the cusps on the brush form an arrow ˄ when seen from above in
the forward movement direction (Fig.6).
4
4
2
2
73.
5
68
68
3
3
6
Publicidad
