Rothenberger RO DD AMPShare Instrucciones De Uso página 20

3 Function of the Unit
3.1 Overview
1 Tool holder
2 Keyless chuck
3 Torque presetting ring
5 Gear selector switch
6 Belt clip
7 Rechargeable battery
3.2 Battery
Charging the battery:
Use only the chargers listed in the technical data. Only these chargers are matched to
the lithium-ion battery of your power tool!
Note: Lithium-ion rechargeable batteries are supplied partially charged according to international
transport regulations. To ensure full rechargeable battery capacity, fully charge the rechargeable
battery before using your tool for the first time.
Inserting the Battery:
Push the charged battery into the battery holder until it clicks into place.
Removing the Battery:
To remove the rechargeable battery, press the battery re-lease button and pull the battery out.
Do not use force to do this.
The rechargeable battery has two locking levels to prevent the battery from falling out if the bat-
tery release button is pressed unintentionally. The rechargeable battery is held in place by a
spring when fitted in the power tool.
Battery charge indicator:
The green LEDs on the battery charge indicator indicate the state of charge of the battery. For
safety reasons, it is only possible to check the state of charge when the power tool is not in op-
eration.
Press the button for the battery charge indicator
so possible when the battery is removed.
If no LED lights up after pressing the button for the battery charge indicator, then the battery is
defective and must be replaced.
The state of charge of the battery is also displayed on the user interface Status indications.
RO BP 18V ProCORE AMPShare
LED
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Recommendations for Optimal Handling of the Battery:
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to 50 C. Do not leave the battery in
your car in the summer, for example.
Occasionally clean the ventilation slots on the battery using a soft brush that is clean and dry.
A significantly reduced operating time after charging indicates that the battery has deteriorated
and must be replaced.
16
8
9
10
11
12
13
or
RO BP 18V AMPShare
Capacity LED
80–100 % 3× continuous green light
60–80 % 2× continuous green light
40–60 % 1× continuous green light
20–40 % 1× flashing green light
5–20 %
0–5 %
ENGLISH
Battery release button
Worklight (LED)
Rotational direction switch
On/off switch
Bit holder
Handle (insulated gripping surface)
to show the state of charge. This is al-
(A)
Capacity
60–100 %
30–60 %
5–30 %
0–5 %