Rothenberger RO DD AMPShare Instrucciones De Uso página 21

Follow the instructions on correct disposal!
3.3 Operating
Changing the tool (B1):
Remove the battery from the power tool before carrying out work on the power tool
(e.g. maintenance, changing tool, etc.). The battery should also be removed for
transport and storage. There is risk of injury from unintentionally pressing the on/off
switch!
The drill spindle is locked when the on/off switch (11) is not pressed. This makes it possible to
change the application tool in the drill chuck quickly, conveniently and easily.
Open the keyless chuck (2) by turning it in the direction of rotation 1 until the tool can be insert-
ed. Insert the tool.
Firmly tighten the keyless chuck (2) by turning it by hand in the direction of rotation 2. This will
automatically lock the drill chuck.
Dust/Chip Extraction:
Dust from materials such as lead-containing coatings, some wood types, minerals and metal can
be harmful to one's health. Touching or breathing-in the dust can cause allergic reactions and/or
lead to respiratory infections of the user or bystanders.
Certain dust, such as oak or beech dust, is considered carcinogenic, especially in connection
with wood-treatment additives (chromate, wood preservative). Materials containing asbestos
may only be worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the ma-terials to be worked.
Avoid dust accumulation at the workplace. Dust can easily ignite!
Starting Operation:
Inserting the battery:
Note: The use of batteries unsuitable for your power tool can lead to malfunctions or damage to
the power tool.
Push the charged battery (7) into the base of the power tool from the front until the battery is se-
curely locked.
Setting the rotational direction (B2):
The rotational direction switch (10) is used to change the rotational direction of the power tool.
However, this is not possible while the on/off switch (11) is being pressed.
Right rotation: To drill and to drive in screws, press the rotational direction switch (10) through to
the left stop.
Left Rotation: o loosen and unscrew screws and nuts, press the rotational direction switch (10)
through to the right stop.
Setting the operating mode:
Drilling
Set the torque presetting ring (3) to the "drilling" symbol.
Screwdriving
Set the torque presetting ring (3) to the required torque.
Switching on/off:
To start the power tool, press and hold the on/off switch (11). The LED (9) lights up when the
on/off switch (11) is lightly or fully pressed, meaning that the work area is illuminated in poor
lighting conditions.
To switch off the power tool, release the on/off switch (11).
ENGLISH
(B)
17