Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
remove plug from power source outlet
before making any adjustments .
1 . Carrying Handle
This handle is built into the head assembly
for transportation.
2 . Arbor lock
Allows the user to keep the blade from
rotating while tightening or loosening arbor
screw during blade replacement or removal.
3 . Lock-Off Switch
The left or right hand ambidextrous switch
must be pressed to activate the power
switch.
4 . Switch
The power switch used with the ambidextrous
switch energizes the unit.
5 . Switch Handle
This handle contains the switch. The blade
is lowered into the workpiece by pushing/
pulling down on the handle.
6 . Lower Blade Guard
The lower blade guard helps protect your
hands from the spinning blade. It retracts as
the blade is lowered.
7 . Blade
Use only 12" blades with 1" arbor hole.
8 . Fence
Supports the workpiece. The fence has a
cast in scale to make repetitive cuts easy.
The fence also has holes which are used to
secure an auxiliary fence if desired.
9 . Kerf Insert
Minimizes workpiece tear-out.
10 . Tool Mounting Pads
Four areas to clamp, bolt or nail the saw to a
flat work surface.
11 . Vertical Clamp
Provides fast clamping of workpiece.
12 . Miter Lock Knob
The miter lock knob locks the miter saw table
at any desired miter angle.
13 . laser Cutline™
Your miter saw is equipped with a laser cut
line to help identify where the blade will
contact the workpiece.
14 . Miter Scale
To avoid injury from
accidental starting,
This scale allows you to read the miter
angles easily.
15 . Miter Detents and Miter Detent Lock
Lever
There are nine (9) miter detents for fast and
accurate miter cuts of common miter angles.
16 . Table
Sits in base, provides workpiece support,
rotates for desired miter cuts and rotates the
head assembly.
17 . Vertical Clamp Positions
There are two (2) positions in the base for
the workpiece clamp.
18 . Base
Provides working surface to support
workpiece.
19 . Accessory Extension Holes
Machined holes that accept the extension
rail.
20 . Extension Rails
Rails used to support long workpieces and
table extension.
21 . Table Extension
This provides extra support and clamping
area.
22 . Sliding Fence
Provides maximum height support for
the workpiece and slides to left for easy
compound cuts.
23 . Lock pin
The compound miter saw is equipped with a
lock pin used to lock the head assembly in
the lower position.
24 . Laser On/Off Switch
Turns the laser alignment system on and off.
25. Chip Deflector
This protects against large chips from
entering the upper guard.
26 . Lower Guard Actuation link
Allows for smooth movement of the lower
guard.
27 . Upper Blade Guard
Covers upper portion of the blade.
28 . Hex wrench
Used for tightening/loosening blade and
adjusting fence. Hex wrench is stored in the
back of the sliding fence.
17
Publicidad
