Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION TO A POWER SOURCE
Double Insulated Tools
Double insulation
need for the three wire grounded power cord and grounded power supply system. It is a
recognized and approved system by Underwriter's Laboratories, CSA and Federal OSHA
authorities.
WARNING
WARNING
WARNING
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. To
reduce the risk of electrical shock, do not change the plug in any way.
EXTENSION CORDS
WARNING
WARNING
overheating. The table shows the correct size to use, depending on cord length and
nameplate amperage rating of tool. If in doubt, use the next heavier gauge. Always use U.L.
and CSA listed extension cords.
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT
Tool's Ampere
Rating
3-6
6-8
8-10
10-12
12-16
NOTE: The smaller the gauge number, the heavier the cord.
8
is a design concept used in electric power tools which eliminates the
Servicing of a tool with double insulation requires care and knowledge of
the system and should be performed only by a qualified service technician.
WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS.
POLARIZED PLUGS. To reduce the risk of electrical shock, your tool is
equipped with a polarized plug (one blade is wider than the other), this
Replace damaged cords immediately. Use of damaged cords can shock,
burn or electrocute.
If an extension cord is necessary, a cord with adequate size conductors
should be used to prevent excessive voltage drop, loss of power or
ALTERNATING CURRENT TOOLS
Cord Size in A .W .G .
Cord Length in Feet
25
50
18
16
18
16
18
16
16
16
14
12
"SAVE THESE INSTRUCTIONS"
100
150
16
14
14
12
14
12
14
12
—
—
Wire Sizes in mm
Cord Length in Meters
15
30
60
0.75
0.75
1.5
0.75
1.0
2.5
0.75
1.0
2.5
1.0
2.5
4.0
—
—
—
2
120
2.5
4.0
4.0
—
—
Publicidad
