Publicidad
Idiomas disponibles
Idiomas disponibles
Removal and Installation of the
Blade
WARNING
any assembly, adjustment or repair to avoid
possible injury.
Note: Clean blade of any excess oil before
installation.
1. Rotate the lower guard 1 by hand. Loosen,
but do not remove, the cover plate screw
2 using a Phillips or straight screwdriver
(Figure 2).
2. Rotate the cover plate 3 counterclockwise
so the blade bolt 4 is exposed (Figure 2).
3. Press and hold the arbor lock. Use the
large hex wrench to remove the blade bolt
4 by turning wrench clockwise. NOTE: The
blade screw has a left hand thread.
4. Remove the blade bolt 4, outer washer 5
and the blade 6. Inner washer 7 does not
need to be removed (Figure 3).
5. To install the 12" blade, fit blade between
the chip deflectors 8 and onto the inner
washer shoulder 9 (Figure 3 & 4). NOTE:
Make sure the rotation arrow on the blade
matches the clockwise rotation arrow on
the lower guard.
Do not use saw blade rated less than 4500/
min(Rpm) .
WARNING
than 12" diameter and 1" arbor. The maximum
kerf thickness of the saw blade is 1/8''.
6. Replace the outer washer 5 in the proper
orientation, and tighten blade bolt 4
finger tight. Press the arbor lock and
tighten blade bolt 4 securely, but do not
overtighten.
7. Rotate cover plate 3 clockwise to original
position. Tighten the screw 2.
WARNING
place. Lower guard will not function properly.
WARNING
when the lower blade guard is not operating correctly. Check the lower blade guard for correct
operation before each use; it should move freely and instantly returns to the closed position. If
the lower blade guard does not snap closed at any time, contact a SKIL Factory Service
Center or Authorized SKIL Service Station.
Disconnect plug from power
source before performing
To avoid injury, do not use
a blade larger or smaller
Never use saw without
cover plate securely in
To avoid possible serious
injury, never use the saw
Fig. 2
1
Fig. 3
5
4
6
Fig. 4
3
2
4
5
6
8
7
9
9
8
21
Publicidad
