Zipper ZI-STE2000IV Manual De Instrucciones página 32

11.1.4 Check the air filter
Check the core of the air filter, ensuring that it is
clean and performs well.
Dismantle the repair cover, loosen the screw on
the cover of the air filter, and then dismantle the
cover of the air filter to check the core.
Please clean or change the core if necessary.
A – Screw of the repair cover (Fig. I)
C – Air filter (Fig. J)
E – Screw of the air filter (Fig. J)
11.2 Start the engine
Before starting the engine, cut off the load from the alternating current socket on the engine.
a) Totally turn the valve to the "OPEN" position clockwise.
1 – The ventilating pole of fuel-filling lid (Fig. K)
ATTENTION:
During commissioning, see note 3.3 on page 18!
b) Turn the switch of the engine to the "OPEN" position
c) Turn the pulling pole of the air-blocking valve to the "CLOSE" position
when the engine is hot or the environmental temperature is relatively high, do not use
the air-blocking valve.
1 – Close (Fig. M) 2 – Pulling pole of the air-blocking valve (Fig.
a) Pull the starting hold (Fig. N) slightly until
you feel the pressure, then release the hold
slowly by hand.
b) When the engine is warming up, turn the
pulling pole of the air-blocking valve to the
"START" position.(Fig. O)
1 – Run / operate (Fig. O)
ZIPPER MASCHINEN GmbH
ZI-STE2000IV
M)
2 – Pulling pole of the air-blocking
valve (Fig. O)
www.Zipper-Maschinen.at
Do not run the engine without the
air filter, or else filth will enter the
engine through carburetor,
resulting in quick wear and tear of
the engine.
B – Repair cover (Fig. I)
D – Cover of the air filter (Fig. J)
F – Core of the air filter (Fig. J)
2 – Switch of the engine (Fig. L)
I M P O R T A N T
Do not let the starting hold (Fig. N)
rebound, and release it slowly by
hand.
If the engine can not restart after
halting, check the oil level ahead of
other failures.
OPERATION
3 – Close (Fig. M)
3 – Start (Fig. O)
32