Publicidad
Idiomas disponibles
Idiomas disponibles
Rememeber that the hob must
not be sealed with silicone. The
warranty will no longer be
valid if this happens.
If your cooking hob is an induction hob,
follow these indications:
•
Make sure the induction hob is well
ventilated and that the air inlet and
outlet are not blocked. Make sure that
the induction hob works correctly as
described below.
•
Keep in mind that induction hobs
technology is based on a magnetic
field created beneath the glass. Heat is
directly transferred to the containers
over the hob, but the glass is not heated.
This accumulated heat which is not
transferred to the glass is evacuated
through the bottom part of the hob and
therefore it is very important to follow
the installation guidelines so that the
hob is correctly ventilated.
•
If the induction hob is installed over a
drawer keeping the minimum distance
and correctly ventilated, there is the
possibility that the drawer and the
utensils in it get hot. This is not a
failure.
•
Induction hobs must be installed by
qualified technicians or personnel,
only. Our company has professional
technicians at your service. Do not
install the hob yourself.
•
The
cooking
installed over a dishwasher, fridge,
freezer, washing machine or dryer;
humidity could damage the electronic
components of the hob.
•
The induction hob must be installed
to guarantee an optimal heat radiation
and reliability.
•
The wall and the surface above the
heating area must be heat resistant.
For
both
types
induction), please follow the following
instructions before installation:
•
The installation surface
and levelled, and no other structural
part must interfere in the space
hob
must
not
(glass-ceramic
must be flat
requirements
Remember that the hob must
not be sealed to the kitchen
countertop or any other surface
with silicone. If this is done, the
warranty will no longer be
valid.
Selection of installation equipment
•
To attach the seal, clean the cooktop
in the area of the cut out section. After,
attach the seal along the outer edge of
the glass plate. Do not extend it. Let the
cut ends stay in the middle of one side.
When you cut it to length (add some
mm), push the two ends together and
don't leave any gap between the two
ends.
(See image 3 on page 6).
•
Cut out the work surface according to
the sizes shown in the drawing
4 on page
•
For the purpose of installation and
use, a minimum of 5 cm space shall be
preserved around the hole.
•
Be sure the thickness of the work
surface is at least 30mm. Please select
heat-resistant work surface material to
avoid larger deformation caused by the
heat radiation from the hotplate.
• Under
sure the Induction cooker hob is well
ventilated and the air inlet and outlet
are not blocked. Ensure the Induction
cooker hob is in good work state. (See
picture 4 on page 6).
be
Note:
between the hotplate and the
cupboard above the hotplate
should be at least 760mm.
The safety distance between
the induction hob and any
object below it must be at least
50 mm
and
Please note that the operation of the
induction hob is based on a magnetic
field that is created underneath the glass.
The heat goes directly to the base of the
containers on the plate, but does not heat the
6).
any
circumstances,
The
safety
EN
(image
make
distance
45
Publicidad
