Seca 604 Instrucciones De Uso página 113

Fault/error code
E02.10
E02.13
E02.16
E02.19
to
E02.20 E02.23
E02.24
E09.02
12.3 Measuring weight (seca 496)
Fault/error code
Displayed weight is implausi-
ble
The function can-
Autohold
not be deactivated
to
001-272XX-XXX
008-272XX-XXX
010-272XX-XXX
Cause
Scale has been switched on with too
high a load
Oscillations have been induced in
scale, zero point could not be deter-
mined
Maximum capacity exceeded
Ambient temperature too high or too
low
One corner of the scale has been
loaded excessively
No GAL value
Communication error between weigh-
ing platform and display
NOTE
For bed scales: The error messages indicate whether they refer to
weighing platform A or B.
− XXX-XXXXX-XXX [A] = Error message for weighing platform A
− XXX-XXXXX-XXX [B] = Error message for weighing platform B
Cause
Weighing electronics using outdated
zero point
Weighing electronics defective
Device is connected to a network (in-
tended behavior): The
Autohold
tion is activated automatically
Load cell or weight calculation module
defective
Scale has been switched on with too
high a load
• Remove the weight from the weighing
platform
• Restarting the device
• If the error recurs, inform seca Service
• Restarting the device
• If the error recurs, inform seca Service
Ask patient to step off the scale
Observe ambient conditions for operation,
transport, and storage
è General technical data, page 125
• Distribute weight evenly
• Restarting the device
• If the error recurs, inform seca Service
Inform seca Service
• Restarting the device
• If the error recurs, inform seca Service
• Remove the weight from the weighing
platform
• Restarting the device
• Wait until main screen is displayed again
Inform seca Service
If necessary, disconnect device from net-
func-
work
Inform seca Service
• Remove the weight from the weighing
platform
• Restarting the device
• If the error recurs, inform seca Service
English
Remedy
Remedy
Troubleshooting • 113