Basic Operation - Eschenbach vario DIGITAL FHD 16591 Manual De Instrucciones

Basic operation

Place the device on the base plate 2$. Unfold the base
arm 2) on the device until it engages (see illustration). The
camera h is equipped with a cover g. Open the camera
EN
cover and move it to the intended position (see illustration
on fold-out pages A1 and A2). If the symbol is shown,
the camera cover has not been opened.
Use the joint 1( to set the required screen height and tilt
angle.
Connect the power adapter to a suitable device plug. Connect its cable to the connection
for the power adapter 2@. Then plug the power adapter into the power socket.
The charging control LED 2! lights up while the device is being charged.
To fold the device together again move the screen to the rear. Then fold the camera
together and close the camera cover (see illustration). Thereafter, fold the base arm
downward.
Turning on/off
Press the On/Off button t. The camera image will appear on the screen q after a few
seconds. Symbols briefly show the current status, for example magnification factor and
brightness setting.
To turn the device off, press and hold the On/Off button t for one second. Current
settings are saved.
Reading with the device
Turn the device on and place the reading material on the base plate 2$ under the
camera h.
In exceptional cases it can make sense to relocate the field of vision to the upper area
of the base plate. To do this, swivel the camera out past the locking position.
- 21 -