Eschenbach vario DIGITAL FHD 16591 Manual De Instrucciones página 32

Adjusting the timeout function
By default, the device turns off automatically after approximately 15 minutes, if it is not
being used. Select this symbol and then press the
to approximately 8 hours.
EN
Updating the firmware
Select this symbol and then press the
firmware on the device and to update it if necessary. If you have registered your vario
DIGITAL FHD, you will be notified about any available firmware updates.
To update the firmware please proceed as follows:
1. Connect the vario DIGITAL FHD to a PC using the provided USB cable. Ensure that
the SD card is inserted in the card slot a.
2. Turn the vario DIGITAL FHD on. The contents of the SD card will now be displayed
on the PC as the "ESCHENBACH" drive.
3. Now open the web address that was provided to you in the email about the firm-
ware update using the connected PC.
4. Download the firmware update and save it directly on the drive - not in a drive
subfolder.
5. Disconnect the vario DIGITAL FHD from the PC using the "Unplug and eject hard-
ware" function, whose symbol you can find on your operating system taskbar.
6. Open the settings menu, select the
7. Select the
to the previous page, select the
The following icon will be displayed on the screen during the firmware update:
symbol and press the
button e to extend this period up
button e to display the current version of the
symbol and press the
button. To cancel the update and return
symbol and press the
- 28 -
button.
button.