Door Open/Close Programming; Radio Code Personalisation And Programming - Erreka FENIX Manual Del Instalador

3

DOOR OPEN/CLOSE PROGRAMMING

Finish the programming
After opening, the door closes and the operator
remains on standby. The display shows "

The upper and lower limits are memorised.
4

RADIO CODE PERSONALISATION AND PROGRAMMING

Trinary, fixed code programming

The memory can only store one code. When
programming a new code, the previous code is
deleted.
1 Ensure the operator is programmed to record fixed
code transmitters (see "Fixed code (trinary) or roller
code transmitter (6)" on page 64).
Standard roller code programming

The memory can store up to 20 different codes.

When the memory is full, the display shows "=". To
completely delete the memory, press CODE for 5
seconds. All the transmitters are deleted (it is not
possible to delete just some of them).
1 Ensure the operator is programmed to record rolller
code transmitters (see "Fixed code (trinary) or roller
code transmitter (6)" on page 64).
1 Start the closing: press the SET button for at least
5 sec.

The door begins to close and the display flashes
"
2 Slowdown in closing: press the SET button when
the door is almost fully closed (*), in order to reduce
the speed before reaching the stopper.
3 Finish the closing: press the SET button to
determine the lower limit.

The display flashes "
4 Start the opening: after closing, the door begins to
open without pressing any button.
5 Slowdown on opening: press the SET button
when the door is almost fully open, in order to
reduce the speed before reaching the stopper.

The display flashes "
6 Finish the opening: press the SET button to
determine the upper limit.

Slowdown: the starting points for slowdown, both
H
in opening and in closing, are determ in ed
".
automatically.
2 Press the CODE button for at least 2 sec.

The display shows "F", indicating that the
operator is ready to memorise the code.
3 Press the operation button of the transmitter to be
memorised.

The letter "F" flashes for a few moments, with
the operator then remaining in operation mode
(the display flashes "
2 Press the CODE button for at least 2 sec.

The display shows "r", indicating that the
operator is ready to memorise the code.
3 Press the operation button of the transmitter to be
memorised.

The letter "r" flashes for a few moments, with
the operator then remaining in operation mode
(the display flashes "
STARTING UP AND PROGRAMMING
L
".
L
".
L
".
H
" or "
H
" or "
FENIX Garage door opener operator
h
").
h
").
61