Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING UP AND PROGRAMMING
Roller code programming, personalised
Personalising the code
The code can be personalised using a pre-
programmed transmitter. The receiver will therefore
only
programme
personalisation. Once the personalisation is
complete, no cancellations or deletions are
allowed.
1 Ensure the operator is programmed to record rolller
code transmitters (see "Fixed code (trinary) or roller
code transmitter (6)" on page 64).
Code programming
The memory can store up to 20 different codes.
When the memory is full, the display shows "=". To
completely delete the memory, press CODE for 5
seconds. All the transmitters are deleted (it is not
possible to delete just some of them).
1 Ensure the operator is programmed to record rolller
code transmitters (see "Fixed code (trinary) or roller
code transmitter (6)" on page 64).
5
PARAMETER ADJUSTMENT
In order to enter parameter adjustment mode, keep the
button |+ pressed down until the letter P appears. The
next diagram shows a graphic representation of the
programming process.
H/h ÁP Ó1
62
Installation Manual
transmitters
with
Maximum
Maximum
thrust in
thrust in
opening
closing
Á
2
É
É
Select value
Select value
(1 .. 8) by
(1 .. 8) by
way of
way of
|+ and |-
|+ and |-
É
É
1
2
Ú
Ú
H/h
H/h
2 Press the CODE button for at least 2 sec.
The display shows "r", indicating that the
this
operator is ready to personalise the code.
3 Press
the
transmitter to be memorised (see the transmitter
instructions).
The letter "r" flashes for a few moments, with
the operator then remaining in operation mode
(the display flashes "
2 Press the CODE button for at least 2 sec.
The display shows "r", indicating that the
operator is ready to memorise the code.
3 Press the operation button of the transmitter to be
memorised.
The letter "r" flashes for a few moments, with
the operator then remaining in operation mode
(the display flashes "
This process is explained in detail after the diagram.
Auto or
step-by-step
Precise
mode and
adjustment
standby
of the lower
time
limit
Á
3
Á
É
Select value
Adjust the
(1.. 8,N) by
position
way of
using
|+ and |-
|+ and |-
É
3
Ú
H/h
H/h
programming
minibutton
H
h
" or "
").
H
h
" or "
").
Slowdown
distance
4
Á
5
Á
É
É
Select value
(1.. 4) by
way of
|+ and |-
É
É
4
5
Ú
Ú
H/h
of
the
Fixed or
roller code
6
É
6
(flashing)
Ú
Select value
(F,r) by way
of
|+ and |-
Ú
1 sec.
6
Ú
H/h
Hide quick links:
Publicidad
Capítulos
Tabla de contenido
