CONOR WRC ISO 4210 Manual De Instrucciones página 64

10. BICYCLE ADJUSTMENT
1. The rear wheel does not have to touch the floor, using a proffesional
work bench or turn it over and placig in the floor.
2. Place the rear derailleur
The chain have to be in the smaler freewheel.
3. Check the strech of the cable and the right place of the screw.
After certain usage of the bicycle the rear derailleur inner cable
could need some readjustement.
If there is not too much cable streched, the chain does not move
correctly from a freewheel to another.
4. Strech the end of the cable and tighten the bolt to hold it.
5. Pull out the cable with a plier while holding firmly the bolt.
6. While the wheels are moving, press the rear derailleur shifters slowly
towards and backwards. As shifters are pressed towards, chain
will move to the smallest freewheel. And if shifters are pressed
backwards, chain will move to biggest freewheel.
7. When shifter is in front position, in order to adjust the chain properly,
turn the "H"screw till the biggest freewhell is lined with the rear
derailleur pulley.
8. Place the rear derailleur lever in the biggest freewheel to be in the
low speeds.
9. Check the chain remain in the smaller freewheel.
24