Total Resetting Of Setup Parameters - Ducati Energia REGO 5 Manual De Instrucciones

(in the case of traditional power factor correction of loads) press the M
key: the word "OFF" will appear to confirm the selection.

12.9 TOTAL RESETTING OF SETUP PARAMETERS

This command reinstates all the default parameters and returns the
controller to the initial starting up condition; after this operation, reset the
controller by following the directions in chapter 7 for POWERING UP FOR
THE FIRST TIME (after setting the IL parameter, the controller always
starts the procedure for acquiring banks, see chap. 7.3 - Page 63).
Press L + M to access the setup menu and press the DATA key
repeatedly until the set logic (1:1:1, 1:2:2, 1:2:4) is displayed; to reset
the controller, keep ALARM/RESET pressed for 5 seconds. The letters
"CLr" will be displayed in turn with the default setting "no".
The parameter can be changed using the L or M key and confirming
with the DATA key. The possible choices are:
no = no reset will be carried out.
yes = the parameters will be reset; during this phase the
controller will switch off all the steps and the digits
8.8.8. will appear for a few seconds with all LEDs
illuminated
81