Rear Panel (Connections); Power Switch; Placing Batteries - Boss ME-80 Manual Del Usuario

Rear Panel (Connections)

GUITAR INPUT jack
Connect your guitar .
Gt. AMP OUTPUT jacks
Connect these to your guitar amp or mixer .
If using a mono connection, use only the "L"
jack .
REC OUT/PHONES jack
Use a stereo-mini plug to connect your headphones (sold
separately) or recorder .
When you connect a stereo-mini plug to this jack, the internal
guitar amp simulator will be automatically on so that you can
also enjoy the powerful guitar sound with your headphones .
In this case, the sound from Gt . AMP OUTPUT jacks will have
the same effect .
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections .
Caution
Handle batteries carefully
* If used improperly, you risk the dangers of fluid leakage,
overheating, combustion, explosion, etc . Carefully observe the
following:
• Do not heat, disassemble, or toss them into a fire or water .
• Do not expose them to sunlight, flame, or any other source of
extreme heat .
• Do not attempt to charge a dry cell battery .
DC IN jack
AUX IN jack
This jack is for connecting an AC adaptor (BOSS
Use a stereo-mini plug to
PSA series; sold separately) .
connect your audio player .
Use your audio player's * Use only the specified AC adaptor
volume control to
control the volume
of Gt . AMP OUTPUT
jacks and REC OUT/
PHONES jack .
[POWER] switch
Turns the unit on and off (p . 4) .
USB COMPUTER port
Use a USB cable to connect to a
computer and exchange audio and
MIDI data between the ME-80 and the
computer (p . 17) .

Placing batteries

Place batteries in the battery box on the bottom of the unit . Make
sure that batteries are facing the correct direction .
* When turning the unit over, be careful so as to protect the buttons
and knobs from damage . Also, handle the unit carefully; do not
drop it .
* We recommend that you keep batteries installed in the unit even
though you'll be powering it with the AC adaptor . That way, you'll
be able to continue a performance even if the cord of the AC
adaptor gets accidently disconnected from the unit .
* If you handle batteries improperly, you risk explosion and fluid
leakage . Make sure that you carefully observe all of the items
related to batteries that are listed in "USING THE UNIT SAFELY" and
"IMPORTANT NOTES" (separate sheet "Read Me First" and Owner's
manual p . 21) .
(PSA series), and connect it to an
AC outlet of the correct voltage .
Do not use any other AC adaptor,
since this may cause malfunction .
Panel Descriptions
To prevent the inadvertent
disruption of power to your unit
(should the plug be pulled out
accidentally), and to avoid applying
undue stress to the DC IN jack,
anchor the power cord using
the cord hook, as shown in the
illustration .
Security slot ( )
http://www.kensington.com/
3