Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Pass the electrical connection wires
through the cable cross-hole and pull
out via the front side.
3. Remove the wire clip; connect the
electrical wire to the wiring terminal
according to the color. Tighten the
screw and fasten the electrical wire
with the wire clip.
NOTE:
•
After tightening the screw, tug slightly on the electrical cord to ensure that it is
properly fastened.
•
Never shorten or extend the electrical wire length by cutting it or adding extensions.
4. Replace the wiring cover and insert the screw.
5. Close the panel after tightening the wiring cover screw.
IMPORTANT ELECTRICAL WIRING INFORMATION
•
All wires of the indoor and outdoor unit must be connected by a qualified electrician.
•
If the length of the electrical cord is unsuitable (too long or too short), contact
your dealer for replacement solutions. Never try to extend or shorten the wire
by yourself.
•
Always ensure that the electrical outlet is easily accessible after installation.
•
If you prefer an installation without an electrical outlet, you must install a dedi-
cated circuit breaker for the unit. The circuit must be all-pole parting; the contact
parting distance must be greater than 3mm.
09、12、18、24K:
（for some model）
2
3
N(1)
2
3
N(1)
outdoor unit connection
–16–
cable-cross
hole
electrical
connection wire
GWC24MD-D3DNC2D
N(1)
2
3
N(1)
2
3
L1 L2
Outdoor unit connection
G
Publicidad
Tabla de contenido
