Changing Needle; To Check The Needle - Janome 2041 Manual De Instrucciones

Changing Needle

Raise the needle by turning the handwheel toward you and
lower the presser foot.
Loosen the needle clamp screw by turning it counterclockwise.
Remove the needle from the clamp.
Insert the new needle into the clamp with the flat side away
from you.
When inserting the needle into the clamp, push it up as far as
it will go and tighten the clamp screw firmly with the screwdriver.
* Check your needles frequently for barbed or blunted points.
Snags and runs in knits, fine silks and silk-like fabrics are
permanent and are almost always caused by a damaged
needle.

To check the needle

Place the flat side of the needle on something flat (needle
plate, glass etc.). The clearance between the needle and flat
surface should be consistent. Never use a bent or blunt needle.
12