Setting Spool Pins; Removing Or Inserting The Bobbin Case - Janome 2041 Manual De Instrucciones

Setting Spool Pins

The spool pins are used for holding the spool of thread in order
to feed thread to the machine.
To use, pull up the spool pin. Push down for storage.
1 Upper thread
2 Hole
3 Tangle
Note :
When using thread which has tendency to tangle around spool
pin, thread through the hole of spool pin as shown. The hole
should face the thread spool.

Removing or Inserting the Bobbin Case

Open the hook cover.
1 Hook cover
Raise the needle by turning the handwheel toward you.
Take out the bobbin case by holding the latch.
2 Latch
When inserting the bobbin case, place the horn into the recess
of the hook race.
3 Horn
1
18
2
1
3
1
2
3