Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION OF THE PARTS OF THE MACHINE
1. Release lever of the lower protective cap
2. Handle for lowering/lifting the head of the
mitre saw
3. Start lever of the mitre saw
4. Saw blade upper protective cap
5. Saw blade
6. Moving lower protective cap of the saw
blade
7. Fence
8. Rotating base of the mitre saw
9. Fixed base of the mitre saw
10. Handle for the rotation of the base for
angle cut
11. Angle indicator for inclined cutting
12. Graduated plate
13. Lever for locking the head of the mitre saw
CAUTION!
Be sure that the mitre saw is switched off and disconnected from any current source before
assembly or any kind of adjustment.
RELEASING THE HEAD OF THE MITRE SAW
1.
Lightly lower the head and keep it in this position.
2.
Pull the locking button of the head 16 Fig. 2.
3.
Lift the head so that it is in its position and ready for working.
To lock the head in a low position, proceed as specified:
1.
Push the locking lever 1 Fig. 2.
2.
Lower the head.
3.
Put the locking button of the head 16 Fig. 2 in its initial position by pushing it.
ASSEMBLY OF THE WORKBENCH'S EXTENSIONS
The mitre saw is provided with two extensions 20 Fig. 1 that can support big workpieces. The
extensions can be assembled on both sides of the mitre saw, according to the dimensions of the
workpiece.
1.
Place the extension in the holes of the mitre saw's base 9 Fig. 1.
2.
Tighten the lock screw of the extensions to lock them.
EN
14. Knurled knob for locking the radial bars
15. Graduated scale of inclined cutting angle
16. Locking button of the head
17. Locking lever of the axle
19. Vertical clamp
20. Workbench's extensions
21. Adjust screw of the inclination stop at 90°
22. Adjust screw of the inclination stop at 45°
23. Angle pointer
24. Dust bag
25. Transport handle of the mitre saw
31. Wrench for the replacement of the saw
blade
35. Saw blade laser pointing device
ASSEMBLY
39
Publicidad
Capítulos
Tabla de contenido
