Automatic Buttonhole - Janome DC 4030 Manual De Instrucciones

q
q
z
e
x
r
w e
w

Automatic Buttonhole

q Stitch pattern:
w Thread tension dial:
e Presser foot:
• Preparation for sewing
q Groove
w Pin
Attach the automatic buttonhole foot R. Make sure the
groove q on the foot holder catches the pin w on the foot
when lowering the presser foot.
e Button holder
r Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0˝
(2.5 cm) in diameter.
Use interfacing on stretch fabrics.
z Pull the button holder e to the back, and place the
button in it. Push it forward tightly against the button.
x Pull the buttonhole lever r down as far as it will go.
48
A
Automatic buttonhole foot: R