skilsaw SPT79 Instrucciones De Funcionamiento Y Seguridad página 13

Connecting Water Feed Assembly
Water feed assembly is
rated for water pressure
up to 80psi. Using water supply higher
than 80psi may damage the water feed as-
sembly creating a hazard.
1. Loosen the nozzle screw using the screw-
driver feature of the wrench (Fig. 6).
2. Insert the nozzle assembly in place and
tighten the screw to secure it. The screw
should engage the screw point recess on
the nozzle.
3. Screw the quick-connect hose adapter onto
the end of the garden hose (not included).
Connect the other end of the garden hose
to a water faucet (Fig. 7).
NOTE: Periodically check and clean the filter.
4. Connect the water feed hose to the hose
adapter by pulling on the collar and then
pressing the water feed hose end into the
quick-connect hose adapter until it snaps in
place (Fig. 7).
NOTE: The quick-connect hose adapter in-
cludes an auto shut-off feature. When the
water feed hose is disconnected the adapter
shuts off water supply.
5. Make sure the water feed valve is in the off
position - valve is perpendicular to the hose
(Fig. 8).
6. Turn on the water faucet. Do not turn the
faucet on high.
7. Turn the water feed valve on (valve is paral-
lel to the hose). To turn the water off, turn
the water feed valve perpendicular to the
hose and turn off the faucet (Fig. 8).
NOTE: You can use the cord clip to temporar-
ily attach the water feed hose to the tool power
cord.
Fig. 8
NOZZLE
1619X09633.indd 13
Fig. 6
Fig. 7
GARDEN
water supply on.
WATER
fEED
VALVE
SCREW
pOINT
RECESS
NOZZLE
SCREW
NOZZLE
SLEEVE
fILTER
HOSE
qUICK-CONNECT
HOSE ADApTER
Do
cleaner along with the
CORD CLIp
SCREW
pOINT
RECESS
WATER
fEED
HOSE
not use vacuum
WATER
fEED HOSE
13
10/7/16 3:58 PM