skilsaw SPT79 Instrucciones De Funcionamiento Y Seguridad página 14

Connecting to Vacuum Cleaner
Always make sure the vacuum cleaner that
you use is designed for extraction of masonry
dust.
Mount the vacuum hose adapter onto the dust
port, located on the outer end of the auxiliary
handle. Tighten the wingnut on the adapter to
secure it in place. The vacuum hose adapter
allows you to connect both 1-7/8" and 2-1/2"
hoses.
NOTE: You don't need the hose adapter
when using Bosch vacuum cleaner Models
VAC090A and VAC090S. The hose end of
Bosch vacuum hose should be mounted
directly onto the dust port. Remove the clamp
from the vacuum hose adapter and secure to
Bosch vacuum hose with wing nut.
Make sure the vacuum hose has freedom to
move and has enough length to complete the
cut. If needed, have another person move the
vacuum cleaner and the hose while you are
making the cut.
Before starting a cut make sure that the air-
flow through the upper guard and auxiliary
handle is unobstructed.
To avoid accidents always disconnect the tool from the power supply
before cleaning or performing any maintenance.
Cleaning
Cleaning After Dry Cutting
The tool may be cleaned most effectively with
compressed dry air. Always wear safety
goggles and respiratory protection when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed ob-
jects through openings.
Cleaning After Wet Cutting
The tool may be cleaned most effectively
by rinsing affected parts with water from the
garden hose immediately after cutting ses-
sion. Always wear safety goggles. Failure
to clean the tool after cutting or allowing the
slurry to dry will result in decreased perfor-
mance of the tool.
Avoid spraying water directly into ventila-
tion openings! Make sure the tool is dry
before reconnecting it to power supply.
Certain cleaning agents
and
14
1619X09633.indd 14
Maintenance
solvents damage
Fig. 9
VACUUM
HOSE
ADApTER
DUST pORT
AUXILIARY
HANDLE
Do
cleaner along with the
water supply on.
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlo rinated cleaning sol-
vents, ammonia and household detergents
that contain ammonia.
Replacing Rollers
Disconnect
from the power source
before making any assembly, adjustments
or changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
If the rollers require replacement simply re-
move the bolts holding the rollers, using the
1/2" hex of the wrench. Replace the rollers and
tighten the bolts back in place.
Use only SKILSAW authorized replace-
ment parts.
Service
Preventive maintenance
performed by unauthor-
ized personnel may result in misplacing of
internal wires and components, which
CLAMp
WING
NUT
not use vacuum
the plug
10/7/16 3:58 PM