Installation - LERICA C254 Manual De Uso Y Mantenimento

Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420
Proceed by carefully following the sequence of points 1 to 10:
1) Unpack the machine (refer to Chap. 4)
aTTENTION!
• after having removed the packaging, check the integrity of the appliance. If in doubt, do not
use the machine and contact the dealer immediately.
• Never tilt or turn the machine over: always move it in the upright position. This prevents the oil leaking
from the vacuum pump.
• Only use man power with utmost care to move the machine.
2) Place the machine on a surface that is flat, stable and suitable for the load.
aTTENTION!
• The appliance must be positioned so as to be accessible from all sides.
• do not obstruct passage-ways, escape or service routes with the machine. do not position
the appliance in front of exits or emergency doors.
• Make sure the machine is ventilated properly, leaving a gap of about 10 cm around the entire appliance.
The ventilation slots must remain free and unobstructed in order to maintain the pump temperature
at a normal level.
3) Open the lid and bring the hinge in the work position.
The machine is supplied with the lid in the resting position
Lift the lid all the way and attach the piston, moving it forward.
88

7. INSTaLLaTION