Menu 4. Select Language; Menu 5. Stand-By Mode; Menu 6. Sound Mode; Menu 7. Initial Load - Bio Bronpi Aire Serie Instrucciones De Instalación, Uso Y Mantenimiento

It is also possible to schedule one automatic start hour and manual stop hour (or vice versa).
Example: START 1: 1:08 hours y STOP 00: "off" or
10.4.5

MENU 4. SELECT LANGUAGE

It allows selecting the languages among those available. To
access this menu you have to confirm with button nº 3 "SET" and
then, choose the selected language among available: Spanish,
Portuguese, Italian, French, English and Catalan with buttons nº 1
and 2 (see drawing D51).
10.4.6

MENU 5. STAND-BY MODE

The stove with the "stand-by mode" activated (see drawing D52) will turn off when the temperature reaches the temperature set plus a
differential (2º C). When the ambient temperature falls to the set
temperature minus a differential (2ºC) the stove automatically restarts
an ignition cycle. It means that if you choose a set temperature of
22ºC the stove wills turn-off when the room temperature is 24º C
and it will restart automatically when the ambient temperature falls
to 20ºC.
In case of the "Stand-by Mode" is deactivated (by default) the stove
will work in "modulation work" when it reaches the set temperature
and that allows the temperature set could be higher.
10.4.7

MENU 6. SOUND MODE

By activating this modality, the stove will emit a sound when the
system detects a fault and goes into the alarm state. To access
to this menu you have to confirm with button nº 3 "SET" and then,
choose "on" with buttons nº 1 and 2 (see drawing D53).
10.4.8

MENU 7. INITIAL LOAD

In case of the stove have no more fuel during the operation; to avoid
an anomaly in the next ignition, it is possible to do a fuel pre-load for
maximum time of 90 seconds to load the screw-type conveyor when
the stove is switched off and cold. To start the load press button nº
2 and to stop it press button nº 4. (see drawing D54).
It is very important that the burner is totally clean when
you start the stove. So, when the initial load is finished, you must check the burner is clean of fuel to do correctly the ignition of the
stove.
10.4.9

MENU 8. STOVE STATE

It shows up the current state of the stove and provides
information about the devices connected. Therefore,
the user can get a technical information. The next
screens are seen automatically (see drawings D55,
D56, D57 and D58).
SMOKE EXTRACTION SPEED
AUGER SPEED
LOAD
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
START 1: "off" and STOP 1: 22:00 hours.
SMOKE TEMPERATURE FAN 2 AND 3 SPEED (NOT AVAILABLE)
STATE 4
STATE
POWER
DIALOGUE
TIME 1 REMAINING TIME INTERMEDIATE CLEANING
STATE
STATE ALARM DELAY
D56
OPERATIONAL STATE
D57 D58
STATE
38
Menu 04
SPA
On
Menu 05
MODE
STAND-BY
On
Menu 06
MODE
SOUND
77"
22º C
LOAD
INITIAL
OPERATIONAL STATE
AL 8
FAILURE
ASPIRATION
ALARM IN PROCESS
D51
D52
D53
D54
D55
AIR SERIES