Harbor Breeze 0080443 Manual De Instrucciones página 22

TROUBLESHOOTING
PROBLEM
There is excessive
wobbling .
The fan operates
correctly, but
the lights are
not working (if
applicable) .
POSSIBLE CAUSE
1 . The blades and/or blade are
loose .
2 . The blades are unbalanced .
3 . The fan mounting is not secure .
4 . The fan is too close to the vaulted
ceiling .
5 . The set screw on the motor
housing yoke is loose .
6 . The blade arms are incorrectly
attached to the blades .
1 . The bulb(s) are not installed
correctly .
2 . The light kit wire plugs are not
connected properly .
3 . There is a faulty wire connection .
4 . The total power of the light is
exceeding 190 W .
CORRECTIVE ACTION
1 . Check and tighten all screws
that hold the fan blades to the
blade arms and the blade arms
to the motor .
2 . Switch one blade with a
blade from the opposite side .
Or balance the fan using a
balancing kit (not supplied) .
3 . Turn off the power . Loosen
the canopy and verify that the
mounting bracket is secure to
the electrical outlet box . The
bracket must be flush without
movement against the outlet
box .
4 . Use a longer downrod or move
the fan to another location .
5 . Lift up the yoke cover and
tighten the set screw to the yoke
until secure .
6 . Reinstall the blades to the blade
arms .
1 . Re-install the bulb(s) .
2 . Ensure that the male and female
plugs in the light kit fitter are
connected properly .
3 . Turn the power off and check all
connections at the ceiling outlet
box .
4 . The fan comes with a 190 W
limiter . When the total watts
of the lights is over 190 W,
the lights do not work . Please
replace the bulbs with lower-
wattage bulbs .
22
Lowes.com/harborbreeze