Assembly; Patient Surface; Patient Surface Motor; Transport / Moving Bed - wissner-bosserhoff Carisma Manual De Instrucciones

13. ASSEMBLY

If required, for example for the purpose of replacement, simple assembly procedures can be
carried out by technically authorised persons.

13.1. PATIENT SURFACE

1. Position the undercarriage.
2. With the help of a second person, place the patient surface on to the lifting
elements so that the screws are at the height of the frame.
3. Twist the remaining screws into the holes intended for them and screw them
firmly to the frame.

13.2. PATIENT SURFACE MOTOR

1. Placed the motor beneath the patient surface into the sockets provided for it and
fix in place with the slider (Fig.4).
2. Connect the slot connections according to the diagram shown below. (Fig. 5)
Abb. 5
Fig. 5

14. TRANSPORT / MOVING BED

Bring bed into mobile position and move bed (see Chapter Brakes / Moving). Hold only the
head and foot ends when moving the bed (see Fig. 2). Under no circumstances may the
bed be pulled/pushed with the side rails!
Caution! When transporting the bed, do not push it over the handset ca-
cable!
When moving the bed, make sure that the feet do not get caught in the
moving castors or in the undercarriage covering.
Page 76
(2) Hubmotor
motor foot
Druckhebel
Pressure lever
(1) Control box
(1) Kontroll-
box (Option)
Abb. 6
Schieber
Slider
Fig. 6
Battery
(3)
(3) Hand-
(option)
Handset (Option)
schalter
(2) Lifting
Fuß
(option)
Control box
Kontrollbox
(option)
(Option)
Akku
Underbed light
(5) Unterbett-
Beleuchtung (option)
(Option)
(4) Lifting
(4) Hubmotor
motor-head
Kopf
Power lead
Netzkabel