Auto Print - OHAUS CW-11 Manual De Instrucciones

CW-11 Indicator
2.8 Initial Scale Setup (Cont.)
2.8.6 Print Menu (Cont.)
Procedure (Cont.)
DATA
Press G/N/T/ MENU button, dAtA 7 is displayed.
This is the data length.
Press PRINT/ UNITS button, and select desired data
length of 7 or 8. Default setting is 7.
STOP BITS
Press G/N/T/ MENU button, StOP 2 is displayed. This
is the stop bit.
Press PRINT/ UNITS button, and select desired stop
bit of 1 or 2. Default setting is 2.

AUTO PRINT

Auto print has settings which enables data to a printer
or PC to be set Off, run continuously, at selected preset
intervals or on stability. On stability will print first stable
non-zero value after each change in weighing value.
Press G/N/T/ MENU button, AP OFF is displayed.
Press PRINT/ UNITS button, and select either Off,
Continous, Interval or On Stability. Default setting is
OFF.
INTERVAL - PRINTING
When interval has been selected in the previous step,
you may now set an interval from 1 to 3600 seconds.
Press G/N/T/ MENU button, int is displayed, after a
few seconds, a second display appears which
allows you to set in the time in seconds.
Pressing the PRINT/ UNITS button advances the zero
from left to right. Sample at left indicates 10 sec-
onds.
NOTE: 0000 not valid.
EN-19