Tabla de contenido
Publicidad
Buttonhole
Pattern selector:
_2_Presser foot:
_3_Thread tension:
_4_Stitch length:
_5] Stitch width:
(BH)
Automatic buttonhole foot
1-5
(0.25-1)
5
* The size of buttonhole is automatically set by placing the
button in the automatic buttonhole foot.
* The button holder of the foot takes a button size up to
2.5 cm (1") in diameter.
Make a test buttonhole on a sample duplicating the fabric,
interfacing and seams of the actual garment.
Place the button on the fabric sample and mark the top and
bottom to determine the position of buttonhole.
Use interfacing on stretch fabrics.
Illi Turn the handwheel toward you to raise the needle to
its highest position.
Raise the presser foot lifter.
121Select the pattern "BH" by turning the pattern selector
dial.
If the BH pattern is already selected, reset the dial once
according to the procedure in 112.
131Attach the automatic buttonhole foot.
1411 P ull the button holder to the back, and place the button
in it. Push back the button holder toward you as far as
it will go.
151Pull the buttonhole lever downward as far as it will go.
d_ Buttonhole lever
161Insert fabric under the foot.
Turn the handwheel slowly towards you with your right
hand until the needle goes down and continue turning
handwheel until the take-up lever is at its highest position.
17 Remove the fabric to the left to draw both threads to
the left.
18 Insert the garment under the foot, and lower the needle
at the starting point.
Then lower the automatic buttonhole foot.
Note:
Make sure there is no gap between the slider and the spring
holder. If there is a gap, the length of the rows will be different
as shown.
_2_Starting point
C3_ Slider
_4_There should be no gap
Spring holder
C6_Difference
®
@
0 _"
"_5
L
F
J
[]%%
[]
[]
%[]%
_J
/
44
Publicidad
Tabla de contenido
