Charging The Battery - Turbo vado SL Manual De Usuario

charger into a power outlet.
Only use the Specialized charger supplied with the bicycle or other chargers approved by Specialized. Inspect
„
the charger before every use for possible damage to the charger itself, the cable or the charging plug. Never use
a charger which you suspect is damaged or know is broken.
You should charge the battery in a dry, well ventilated area and make sure the battery and charger are uncovered
„
during the charging process. Ensure that the battery and charger are not exposed to any flammable or
dangerous substances.
WARNING! Failure to follow the instructions in this section may result in damage to electrical
components on your bicycle and will void your warranty, but, most importantly, may result in
serious personal injury or death. If your battery or charger exhibits any signs of damage, do not
use it and immediately bring it to your Authorized Specialized Retailer for inspection.
WARNING! Place the charger and battery if removed from the frame on a stable, level surface
unaffected by heat. You should charge the battery in a dry, well ventilated area and make sure the
charger is uncovered during the charging process. Ensure that the battery and charger are not
exposed to any flammable or dangerous substances. Plug the charger's plug into an outlet (100
- 240V), using the appropriate plug for the country's standards, then connect the charging plug
with the charging socket on the battery. Specialized recommends charging the battery in an area
with a smoke detector.
CAUTION: Always turn off the bicycle before plugging or unplugging the charger or RE!
INFO: Only charge the battery at an ambient temperature between 0° C and +45° C (+32° F and
+113° F). If outside temperatures are too hot or too cold, charge the battery inside. For safety
reasons, if the battery is too hot or too cold, it will not charge.
Plug the charger's plug into an outlet (100 - 240V), using the appropriate plug for the country's standards.
„
9.2
Locate the charge port on the non-drive-side of the frame, near the bottom bracket.
„
Open the charge port lid (Fig. 9.2) and insert the charging plug into the charge port (Fig. 9.3). Use the arrow on
„
the connector as guidance for the correct orientation.
When charging is complete, disconnect the charging plug from the charge port.
„
Close the charge port lid to seal it against water and debris.
„
Unplug the charger from the wall socket.
„
CAUTION: Always fully close the charge port cover after charging and during riding. It should
remain only open when the optional RE is plugged in.

9.2. CHARGING THE BATTERY

9.3
18