Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL DRIVE OIL
Refer to the safety precautions on page
86.
Change the oil as specified in the
maintenance schedule.
Change the oil with the final drive at
normal operating temperature and the
motorcycle upright on level ground to
assure complete and rapid draining.
1. To drain the oil, remove the oil filler cap
(1) and oil drain plug (2).
2. After the oil has completely drained,
check that the sealing washer (3) on the
drain plug is in good condition and
install the drain plug.
Drain plug torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
102
3. With the motorcycle upright on level
ground, fill the final drive with the
recommended grade oil; approximately:
130 cm
3
(4.4 US oz, 4.6 Imp oz)
Make sure the final drive is filled up to
the lower edge of the inspection hole (4)
with the recommended oil.
4. Install the oil filler cap.
(1) Oil filler cap
(2) Oil drain plug
(3) Sealing washer
(4) Inspection hole
E
Publicidad
Tabla de contenido
