Using The Automatic Wheel Clamping System C; With Using The Automatic Wheel Clamping System - Corghi LaserLine EM 9580 Plus Manual De Uso

WARNING
Never raise the guard before the wheel has
come to a stop.
WARNING
If the wheel keeps spinning permanently due to
a fault on the machine, switch off the machine
using the main switch or disconnect the plug
from the power supply board (emergency stop)
and wait until the wheel stops before raising
the guard.
USING THE AUTOMATIC
WHEEL CLAMPING
SYSTEM C
with using the automatic
wheel clamping system
Wheel locking procedure with the automatic
system C
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the
hub until it comes into contact with the cone.
- Hold the control pedal down until the wheel
is completely locked against the flange.
Centring with cone at rear
- Fit the most suitable cone for the central hole
of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place
until the cone comes into contact with the plate
that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the
hub until it comes into contact with the wheel.
- Hold the control pedal down until the wheel
is completely locked against the flange.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
Centring with flanges
62
C hub removal
- Keep the
for at least 3 seconds to lock the wheel-holder
shaft and the internal devices.
- Insert the C special key provided with the
machine in the C hub hole (fig. 16).
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with
the two screws (A, fig. 17) using the CH 6 wrench.
- Lock the wheel onto the flange as usual.
C hub mounting
Proceed as follows to remount the C hub:
- Keep the button pressed
3 seconds to lock the wheel-holder shaft and
the internal clutch.
- Screw the C hub manually until it reaches the
end position.
- Tighten the C hub by inserting the C special
wrench into the C hub hole (fig. 18).
EM 9580 Plus - EM 9580 C Plus - Operator's manual
keypad button pressed
A
16
17
for at least