Opening The Burner; Closing The Burner - Riello RL 800/M TC FS2 Instrucciones De Uso

Nozzles
It is advisable to replace nozzles every year during regular
maintenance operations.
Do not clean the nozzle openings; do not even open them.
Flexible hoses
Check to make sure that the flexible hoses are still in good con-
dition.
Fuel tank
Approximately every 5 years, or whenever necessary, suck any
water or other impurities present on the bottom of the tank using
a separate pump.
7.3

Opening the burner

Disconnect the electrical supply from the
burner.
DANGER
 Remove the tie rods 1) and 5) (Fig. 35) of the head move-
D11107
7.4

Closing the burner

Refit following the steps described but in reverse order; refit all
burner components as they were originally assembled.
Maintenance
4 2
4 5
3 6
Combustion
In case the combustion values found at the beginning of the inter-
vention do not respect the standards in force or, in any case, do
not correspond to a proper combustion, contact the Technical
Assistant and have him carry out the necessary adjustments.
EN 267
Theoretical max. CO
0 % O
2
15,2
ment and damper opening lever by loosening nuts 2).
 Disconnect servomotor socket 3).
 Disconnect derivation unit socket 6).
 Remove screws 4).
At this point it is possible to open the burner at the hinge.
29 GB
Excess air
Max output
  1,2
Calibration CO %
2
2
 = 1,2  = 1,3
12,6 11,5
1 2
4
4
Min output
  1,3
CO
mg/kWh
 100
Fig. 35
20034064