Malfunctions; After Sales Service - Fox F36-528A Manual De Instrucciones

PROBLEM
The saw does not start:
Machine vibrations:
Wood darkens while cutting:
The tools wear rapidly:
The engine does not work properly:
Blade stops rotating:
The blade rejects the wood:
Other:
All the tools and accessories are made and checked by using the safest and most modern productive methods.
However, if a tool get damaged, it must be repaired by an authorised after sales centre.
You can sending a request to the e-mail address:
EN

MALFUNCTIONS

POSSIBLE CAUSE
The electric current is missing in the socket to which
the supply cable is connected.
The supply cable is faulty
The engine is damaged
The inclination handle is not blocked
The blade is not fixed correctly
The tool is not correctly sharpened
The tool has been assembled back-to-front
The tool is not correctly sharpened
The wood is dirty (cement, sand, etc.)
The engine may be damaged: get the machine
checked by an electrician
Surcharge (the speed is too high, the tool is not
sharpened)
The rip fence is not parallel
The riving knife is not aligned correctly
The bearings make noise: get them changed

AFTER SALES SERVICE

info@fox-machines.com
36