Checking The Chain Brake; Start-Up; Working - Stiga CS 40 Li Manual De Instrucciones

Chain
Guards
Battery
Machine
Throttle trigger lever,
throttle lock button
Test driving
6.2.2 Machine operating test
Action
Fit the battery inside
its housing (par. 7.2.3).
Activate the throttle
trigger lever. (without
pressing the throttle
lock button)
Press the throttle
lock button and
throttle trigger lever.
Release the throttle
trigger lever
CHECKING THE
CHAIN BRAKE
1. Start the machine
(par. 6.3 )
2. Grasp the hand
grips firmly with
both hands.
3. Use the throttle
lever to keep the
chain moving, push
the front hand guard
forwards using the
back of your left
hand (par. 5.3 )
Sharp, not damaged
or worn, mounted and
tensioned correctly.
Intact, undamaged.
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
The levers must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
Result
The chain should
not move.
Do not use the
machine if the chain
moves; in this case,
contact your dealer.
The throttle trigger
lever remains blocked.
The levers must
move freely and
not be forced. The
chain moves.
The lever automatically
and rapidly returns
to the idle position.
The chain should stop.
3. The chain must stop
moving immediately.
When the chain has
stopped, release the
throttle trigger lever
and disengage the
chain brake (par. 5.3).
If any of the results fail to match the
instructions provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.

6.3 START-UP

1. Remove the bar cover guard (Fig. 1.J) and
the spiked bumper guard (Fig. 1.K) (if fitted).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the battery inside its housing
correctly (par. 7.2.3).
4. Press the throttle lock button (Fig 9.B)
and throttle trigger lever. (Fig 9.A).

6.4 WORKING

Before felling or delimbing for
the first time, make sure:
– to have been specifically trained
to use this type of equipment;
– to have carefully read the safety
regulations and user instructions
contained in this manual;
– you practise first on logs on the ground
or attached to trestles, in order to
get familiar with the machine and the
most suitable cutting techniques.
To use the machine proceed as follows:
• Always disengage the chain brake, pulling the
lever towards you before using the throttle.
• The machine must always be firmly held in
both hands, with the left hand on the front
hand grip and the right hand on the rear hand
grip, even if the operator is left-handed.
Stop the machine immediately
if the chain stops during sawing.
NOTE During use, the battery is
protected against total drainage with a
protective device that switches off the
machine and stops it from working.
6.4.1 Checks to be conducted
whilst working
6.4.1.a Checking the chain tension
The chain tends to stretch gradually
as you work, so you need to check its
tension frequently (par. 6.1.3).
6.4.1.b Checking the oil delivery
EN - 9