General Symptoms; Corrective Action - mundoclima AEROTHERM MAM-V9 Serie Manual De Usuario E Instalacion

Before starting the troubleshooting procedure, carry out a thorough visual inspection of the unit and look for obvious defects
such as loose connections or defective wiring.
When carrying out an inspection on the switch box of the unit, always make sure that the main switch of the unit is
switched off.
When a safety device was activated, stop the unit and find out why the safety device was activated before resetting it. Under no
circumstances can safety devices be bridged or changed to a value other than the factory setting. If the cause of the problem
cannot be found, call your local dealer.
If the pressure relief valve is not working correctly and is to be replaced, always reconnect the flexible hose attached to the
pressure relief valve to avoid water dripping out of the unit!
For problems related to the optional solar kit for domestic water heating, refer to the troubleshooting in the Installation
& Owner's manual for that kit.

13.2 General symptoms

Symptom 1: The unit is turned on but the unit is not heating or cooling as expected
POSSIBLE CAUSES
The temperature setting
is not correct.
The water flow is too low.
The water volume in the
installation is too low.
Symptom 2: The unit is turned on but the compressor is not starting (space heating or domestic water heating)
POSSIBLE CAUSES
The unit must start up
out of its operation range
(the water temperature
is too low).
WARNING
NOTE

CORRECTIVE ACTION

Check the controller set point.T4HMAX,T4HMIN in heat mode.
T4CMAX,T4CMIN in cool mode.T4DHWMAX,T4DHWMIN
in DHW mode.
‡ &KHFN WKDW DOO VKXW RII YDOYHV RI WKH ZDWHU FLUFXLW DUH
completely open.
‡ &KHFN LI WKH ZDWHU ILOWHU QHHGV FOHDQLQJ
‡ 0DNH VXUH WKHUH LV QR DLU LQ WKH V\VWHP SXUJH DLU 
‡ &KHFN RQ WKH PDQRPHWHU WKDW WKHUH LV VXIILFLHQW ZDWHU SUHVVXUH
The water pressure must be>1 bar (water is cold).
‡ 0DNH VXUH WKDW WKH H[SDQVLRQ YHVVHO LV QRW EURNHQ
‡ &KHFN WKDW WKH UHVLVWDQFH LQ WKH ZDWHU FLUFXLW LV QRW WRR KLJK
for the pump.
Make sure that the water volume in the installation is above
the minimum required value (refer to "9.3 water piping/
Checking the water volume and expansion vessel pre-pressure").
CORRECTIVE ACTION
In case of low water temperature, the system utilizes the backup heater to
reach the minimum water temperature
first (12°C).
‡ &KHFN WKDW WKH EDFNXS KHDWHU SRZHU VXSSO\ LV FRUUHFW
‡ &KHFN WKDW WKH EDFNXS KHDWHU WKHUPDO IXVH LV FORVHG
‡ &KHFN WKDW WKH EDFNXS KHDWHU WKHUPDO SURWHFWRU LV QRW DFWLYDWHG
‡ &KHFN WKDW WKH EDFNXS KHDWHU FRQWDFWRUV DUH QRW EURNHQ
158