SRAM RockShox Suspension Fork Manual Del Usaurio página 5

Suspension Fork User Manual
7. Check tire clearance whenever you change tires.
ensure there is at least 6 mm of clearance between the top of the inflated tire and the bottom of the
crown.
to compress the fork completely you may need to remove the air pressure or coil spring from
the fork. for complete instructions, refer to the rockshox technical manual available on-line
at www.sram.com or www. rockshox.com.
Failure to leave 6 mm clearance between the top of the inflated tire and the bottom of the crown
will cause the tire to jam against the crown when the fork is fully compressed which can result
in severe and/or fatal injuries.
8. Do not let brake or derailleur cables rest on, or be attached to the crown. Abrasion over time may
cause damage to the crown. If contact is unavoidable, use tape or similar protection to cover the
surface.
Crown abrasion is not covered under warranty.
9. Take your bicycle to a qualified dealer for inspection and repair if there is any question of component
integrity due to a crash or other direct impact.
MaxLe™ Quick reLeaSe Thru axLe SySTeM
important safety information
The Maxle quick release thru axle system allows the use of a 20 mm x 110 mm or
15 mm x 100 mm thru-axle hub for enhanced stiffness. The axle threads into the non-drive
side fork dropout and compresses the hub between the non-drive and drive side fork legs.
The axle is fixed in place in the lower leg by the Maxle quick release lever.
Riding with an improperly installed wheel can allow the wheel to move or disengage from the
bicycle, causing damage to the bicycle, and serious injury or death to the rider. It is essential
that you:
• Ensure that your axle, dropouts, and quick release mechanisms are clean and free of dirt
or debris.
• Ask your dealer to help you understand how to properly secure your front wheel using the
Maxle quick release thru axle system.
• Apply the correct techniques when installing your front wheel.
• Never ride your bicycle unless you are sure the front wheel is installed properly and secure.
Copyright © SRAM, LLC • 2010
To do this, compress the fork completely and
w a r n i n g
English
5