Before Use; Charging The Battery; Baby Unit Power Supply - miniland baby digimonitor 3.5 plus Manual Del Usuario

ENGLISH
5. USAGE INSTRUCTIONS

5.1. BEFORE USE

5.1.1. PARENTS' UNIT POWER SUPPLY AND BATTERY USAGE
The monitor, the parents' unit, of this baby monitor is designed for use with the battery or with
the AC/DC adapter supplied. The rechargeable battery must be charged for at least eight hours
before using the unit for the first time or if it has not been used for a prolonged time period.
Your baby monitor comes with a rechargeable, 3.7V 1200mAh Li-ion battery for the monitor.
We would recommend using the battery in the monitor so as to be able to receive the audio/
video signal from the camera anywhere. Connect the monitor to the adaptor plugged into the
mains whenever possible so as to keep the battery charged.
BATTERY INSTALLATION (FIGURE 3)
1. Unscrew and remove the battery compartment cover (16) situated at the rear of the unit.
2. Insert the Li-ion battery (supplied).
3. Put the battery cover back in its place and secure it with the screw.
Precaution: Only use batteries of the recommended type as otherwise there is a risk of
explosion. Dispose of worn out batteries responsibly.
Note: When you don't use the two units, it is recommended to turn them off in order to
save the battery.

CHARGING THE BATTERY

Insert the rechargeable battery in accordance with the instructions stated in the previous
section.
Connect the AC adapter connector to the mini-USB socket situated on the side of the unit
(14). Only use the adapter supplied. Plug in the adapter to the mains.
Whilst the monitor is connected to the mains and charging, the charging indicator LED (3) will
be lighted in red.
If the charger remains connected to the mains but the charging process is complete, the
charging LED indicator (3) will light in green.
When the level of battery is low, the battery level icon (i) will begin to blink in red and the
monitor will start to beep every 5 seconds.
Note: remove the battery when the appliance is not going to be used for a prolonged
time period.

5.1.2. BABY UNIT POWER SUPPLY

The camera or baby unit of this baby monitor is designed for use with the AC/DC adapter
supplied.
1. Place the connector socket (VII) at the rear of the baby unit.
2. Connect the adapter cable to the mini-USB socket of the camera. Only use the adapter
supplied.
3. Plug in the adapter to the mains.
Warning: Danger of Strangulation – Keep the cable out of reach of the baby. NEVER
place a camera with cables less than 1 metre away from the cot. Never use extension
cables with AC adapters. Only use the AC adapters supplied.
30