miniland baby digimonitor 3.5 plus Manual Del Usuario página 40

ENGLISH
You cannot hear
the parents' voice
in the baby unit
The camera does
not transmit
You cannot hear the
baby on the parent
unit
Interference or poor
reception
You cannot charge
the battery in the
parent unit
If the Baby Unit has
lost its link with the
Parent Unit
The volume setting of the
baby unit is too low
The camera is not turned on
Camera: the power adapter
is not plugged in
VOX mode or Standby
mode are active
The volume setting of the
parent unit is too low
Other electronic devices may
be interfering with the signal
The camera and monitor may
be too far apart
The battery power may be
too low
The camera or monitor may be
placed too close to many metal
objects
The AC/DC adapter is not
plugged in
A non-rechargeable battery
has been used
The camera and monitor
may be too far apart
The link between both units
has been lost momentarily
The link between both units
has been lost
Set the volume to the highest level
Press and hold down button (III) for 2
seconds
Plug in the power adapter
To see the monitored area continuously,
disconnect the VOX or Standby mode
on the Monitor
Set the volumen to the highest level
Move them away from the device
Move the monitor closer to the camera
Plug in the power adapter
Move them away from the device
Plug in the adapter
Only rechargeable batteries can
be used (3,7 V – 1200mAh Li-ion
battery). test the battery and, where
necessary, change it for the one
supplied with the appliance
Move the monitor closer to the
camera
Reset the units by disconnecting them
from the electrical power. Wait about
15 seconds before reconnecting.
Allow up to one minute for the
Baby Unit and the Parent Unit to
synchronize.
Pair the camera and monitor again.
See 5.2.7.1.3.
40