SRAM Rock Shox VIVID Manual Del Usuario página 5

English
10. Re-install and seat the spring retainer, with the graphics facing outward.
11. Turn the preload collar until it contacts the spring and the spring contacts the spring retainer.
1. Re-install the shaft eyelet mounting hardware.
1. Re-install the shock on the bicycle according to your bicycle manufacturer's recommendation.
14. Adjust the sag as outlined in the "Setting Sag" section.
MaintEnancE
To maintain the high performance, safety, and long life of your shock, periodic service is required. If you
ride in extreme conditions, maintenance should be performed more frequently.
:
important any service that requires disassembly of the shock should be performed by a qualified bicycle
.
mechanic with the proper tools and training to obtain service information or instructions
. .
website at www rockshox com or contact your local rockshox dealer or distributor
aftEr EvEry 8 hoUrs of riDing
• Clean your shock with mild soap and a toothbrush.
• keep mounting hardware clean and lubricated.
• Refer to your bicycle owner's manual for correct mounting hardware torque values.
: -
important over torqued mounting hardware can cause damage to the bicycle frame and
. -
shock to bind and malfunction under torqued mounting hardware will damage the frame
.
and shock
aftEr EvEry 20 hoUrs of riDing
• Remove, clean, and grease mounting hardware.
: -
important never use a high powered washer to clean the shock
aftEr EvEry 100 hoUrs of riDing or annUally
• Inspect eyelet bushings and mounting hardware for wear and play. Replace if necessary.
• Inspect shaft, reservoir and Internal floating piston for scratches or damage. Replace if necessary.
• Replace all seals.
• Replace damping fluid.
8
Vivid User Manual
,
visit our
.
/
or cause the
, ,
hardware
.
95-4115-001-000 Rev B
Vivid User Manual
sraM corPoration warranty
ExtEnt of liMitED warranty
SRAM warrants its products to be free from defects in materials or workmanship for a period of two
years after original purchase. This warranty only applies to the original owner and is not transferable.
Claims under this warranty must be made through the retailer where the bicycle or the SRAM component
was purchased. Original proof of purchase is required.
local law
This warranty statement gives the customer specific legal rights. The customer may also have other
rights which vary from state to state (USA), from province to province (Canada), and from country to
country elsewhere in the world.
To the extent that this warranty statement is inconsistent with the local law, this warranty shall be
deemed modified to be consistent with such law, under such local law, certain disclaimers and limitations
of this warranty statement may apply to the customer. for example, some states in the United States
of America, as well as some governments outside of the United States (including provinces in Canada)
may:
a. preclude the disclaimers and limitations of this warranty statement from limiting the statutory
rights of the consumer (e.g. United kingdom).
b. Otherwise restrict the ability of a manufacturer to enforce such disclaimers or limitations.
liMitations of liaBility
To the extent allowed by local law, except for the obligations specifically set forth in this warranty
statement, In no event Shall SRAM or its third party supplies be liable for direct, indirect, special,
incidental, or consequential damages.
liMitations of warranty
This warranty does not apply to products that have been incorrectly installed and/or adjusted according
to the respective SRAM technical installation manual. The SRAM installation manuals can be found
online at www.sram.com or www.rockshox.com.
This warranty does not apply to damage to the product caused by a crash, impact, abuse of the product,
non-compliance with manufacturers specifications of usage or any other circumstances in which the
product has been subjected to forces or loads beyond its design.
This warranty does not apply when the product has been modified.
This warranty does not apply when the serial number or production code has been deliberately altered,
defaced or removed.
This warranty does not apply to normal wear and tear. Wear and tear parts are subject to damage as a
result of normal use, failure to service according to SRAM recommendations and/or riding or installation
in conditions or applications other than recommended.
Wear and tear parts are identified as:
• Dust seals
• Air sealing o-rings
• Rubber moving parts.
• Rear shock mounting hardware
and main seals
• Stripped threads/bolts (aluminium,
titanium, magnesium or steel)
• Brake pads
• Sprockets
• Shifter and brake cables (inner and outer)
• Shifter grips
• Disc brake rotors
This warranty shall not cover damages caused by the use of parts of different manufacturers.
This warranty shall not cover damages caused by the use of parts that are not compatible, suitable
and/or authorised by SRAM for use with SRAM components.
©SRAM Corporation • 007
English
• Bushings
• glide rings
• foam rings
• Upper tubes (stanchions)
• Brake sleeves
• Chains
• Cassettes
• Handlebar grips
• jockey wheels
• Tools
9