Introduction; External Dimensions; System Configuration - Mitsubishi a2 Serie Manual Del Usuario

α
2 Simple Application Controllers
11.1

Introduction

The AL2-2DA Analog Output Module (hereafter called "AL2-2DA") is to be installed onto an
Series Controller and should be used to convert a digital value to a voltage (0~10V) or current
(4~20mA) analog output signal.
The AL2-2DA is to be used in conjunction with the
function block. Refer to the
11.1.1

External Dimensions

Figure 11.1:External Dimensions
2 4 . 5 ( 0 . 9 6 " )
11.1.2

System Configuration

For general specifications please refer to Chapter 2.
Table 11.1: Applicable Version
VLS Software
Note
1) The AL2-2DA cannot be used together with either an AL2-4EX-A2, AL2-4EX, AL2-ASI-BD,
AL2-4EYR or AL2-4EYT.
2) The AL2-2DA cannot be used with the original
α
2 Programming manuals for further details.
V 1 + I 1 + V I 1 -
+
-
P O W E R A N A L O G
2 4 V D C
O U T P U T
A N A L O G
2 D A
O U T P U T
V 2 + I 2 + V I 2 -
5 3 . 1 ( 2 . 0 9 " )
PLC Type
α
2 Series
α
2 Series Controller's Analog Output (AO)
Applicable version
V2.00 or later
V2.30 or later
α
Series Controllers.
AL2-2DA 11
α
2
Unit:mm (inches)
ENG-56