LAVAZZA LB 1102 Instrucciones De Empleo página 15

ELECTRICAL POWER SUPPLY
The machine is designed to be powered by mains elec-
tricity (24 V cc) or by battery power (24 V cc). Use the
selector to change the power supply.
MAINS
SETTING
Make sure that your hand, the machine, the
cable and the surfaces supporting the ma-
chine are not wet.
Insert the plug into the socket.
1
For mains power supply set the selector to
MAINS SETTING. For battery power set the
selector to BATTERY
Press the main power switch, setting it to the I
2
position. The green machine on light signal will
light up. Wait for the three central buttons to
turn on, as shown in the picture. The machine is
now ready for use.
PREPARING THE MACHINE
BATTERY
SETTING
SETTING.
If the selector on the back of the machine is set to
BATTERY SETTING, when the voltage drops be-
low the set threshold the machine will signal this
status by illuminating the green light. In the case of
brewing with voltage at the limit of the set value,
the machine may start brewing and then stop
(with unit controls blocked). This error status will be
indicated by emitting a sound and illuminating the
red light. To bring the machine back to an operative
state, turn it off at the main power switch then turn
it back on. The unit controls will go back to resting
setting, the low power status will be detected and
the machine will go into energy saving mode after
a few moments.
ENERGY SAVING
After about an hour of inactivity the machine
1
goes into energy saving mode. The green light
signal starts to blink and the brightness varies
from maximum to minimum in a continuous cy-
cle.
To restart the machine press a brew coff ee but-
2
ton or raise the capsule loading arm. The green
signal light starts fl ashing.
The machine is ready for use when the green
3
signal light turns off and the three buttons for
coff ee brewing, and water and steam dispensing
are constantly lit.
REMOVING USED CAPSULES
An alternating fl ash of the coff ee brewing but-
tons, anomaly signal light and acoustic signal
indicate that the used capsule drawer is full and
needs to be emptied and reinserted.
E N
13