Maintenance And Cleaning - LAVAZZA LB 1102 Instrucciones De Empleo

Once the desired coff ee amount is reached, stop
5
the brewing by pressing the button again. The
machine emits three sounds indicating the suc-
cessful new programming.
If the programming does not occur in maximum
1'50", the machine automatically stops brewing,
the brewing button flashes and the dose of the last
programmed value remains in the memory. If there
is a power failure during programming, the last
programmed value remains in the memory.
Before cleaning the machine, always make
sure that the power supply is disconnected
and wait until the machine cools.
It is advisable to rinse the water tank daily and after
periods when it hasn't been used, and to refi ll it with
fresh water. Empty and clean the drip tray every
two-three days or when it is full. Do not use a micro-
wave or a traditional oven to dry the machine or its
parts. Never use alkaline cleaners, solvents, alcohol
or aggressive substances. Do not immerse the ma-
chine in water. Unless otherwise specified, all parts
of the machine that cannot be removed (except
electrical) must be washed using cold or lukewarm
water and a non-abrasive cloth or sponge.
CLEANING THE USED CAPSULE DRAWER/
DRIP TRAY
Remove the cup support rack.
1
COFFEE BREWING

MAINTENANCE AND CLEANING

PROGRAMMED COFFEE DOSE BREWING
Perform steps 1, 2, 3 of paragraph
MANUAL COFFEE DOSE BREWING.
Press one of the two coff ee brewing buttons
4
(if programmed). The machine stops brewing
automatically once the preset coff ee dose is
reached.
If there are anomalies during coff ee brewing with
preset dose, the machine continues brewing in
manual coff ee dose mode. The brewing can be
stopped by pressing the button again.
Lift the cup support from the rack
2
Remove the drip tray/used capsule drawer.
3
When the drawer is removed the machine resets the
count of capsules inserted.
E N
15