Control Switches - Migatronic MIG 305x Manual De Instrucciones

Assembly of the welding torch (C-model)
The welding torch is fitted to the central adaptor (pos.
2 page 14), and the connection is fastened by hand. If
the machine has a water module the two water hoses
are fitted to the quick release connectors for water.
Wire feeding
The wire roll combination to the chosen wire diameter
can be seen from the figure page 71. The machine is
delivered with one set of wire rolls etc. as standard.
Other sizes can be delivered. Only parts of the same
colour can be fitted together.
Adjustment of wire brake
The wire brake must ensure that the wire reel brakes
sufficiently quickly when welding stops. The required
brake force is depending on the weight of the wire reel
and the maximum wire feed speed. A brake torque of
1.5-2.0 Nm will be satisfactory for most applications.
Adjustment:
Dismount the control knob by placing a thin screw
-
driver behind the knob and thereafter pull it out
Adjust the wire brake by fastening or loosening the
-
self-locking nut on the axle of the wire hub
- Remount the knob by pressing it back into the
groove.

CONTROL SWITCHES

1. Main switch
2. Inductance output
Recommended wire diameter ø1.8 – 2.0
3. Inductance output
Recommended wire diameter ø1.6 – 1.8
4. Inductance output
Recommended wire diameter ø1.2 – 1.6
5. Inductance output
Recommended wire diameter ø0.6 – 1.0
6. ON
Lights when the machine has been turned on.
7. Adjustment of welding voltage
MIG 305x (1 - 10) fine adjustment
MIG 385x (1 - 12) fine adjustment
MIG 445x (1 - 12) fine adjustment
MIG 545x (1 - 6) fine adjustment
8. Adjustment of welding voltage
MIG 305x (1 - 2) coarse adjustment
MIG 385x (1 - 2) coarse adjustment
MIG 445x (1 - 2) coarse adjustment
MIG 545x (1 - 6) coarse adjustment
9. Overheat error
13
S-MODEL