STERWINS 20 VGT2-28.1 Instrucciones De Montaje página 288

FR • Take care against injury from any device fi tted for trimming the fi lament line length,
if applicable. After extending new cutter line always return the product to its normal
operating position before switching on.
ES
• Never fi t metal cutting elements.
PT
• Never replace non-metallic cutting means with metallic cutting means
• Use of hearing protection reduces the ability to hear warnings (shouts or alarms).
IT
The operator must pay extra attention to what is going on in the work area. Do not get
distracted, and always concentrate on the task.
EL
• Operating similar tools nearby increases both the risk of hearing injury and the potential
for other persons to enter your work area.
PL
• Keep fi rm footing and balance.
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the
RU
footing on slopes.
• Walk, never run. Keep all parts of your body away from any moving part.
KZ
• Never run the product without the proper equipment attached.
UA
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
RO
BR
EN
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
Trimming : Illustration 4.5
Ensure the knife protector 15a is removed before use.
Fold the plant protector 13 in.
Adjust the trimmer head 14 angle to 0° for trimming operation.
Hold the product fi rmly with a gap between the product and your right side.
Stand upright, do not lean forward and pay attention to posture. Keep both feet apart to help retain your
balance.
Hold the trimmer head just above the ground at an angle of approximately 30°.
Move the product with a slow regular arc from left to right before moving it back to the starting position
before trimming the next area.
If the product is dropped, suff ers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
290