Installation; Operating Testomat 2000; Installing Testomat 2000 - Heyl Testomat 2000 PO4 Manual De Instrucciones

!
WARNING
NOTE
Remove for
pressure
range 0.3 to 1
bar


Installation

Risks resulting from incorrect installation!
 Install Testomat 2000
against dripping or splash water, dust and aggressive substances
– e.g. in a switch cabinet or on a suitable wall.
Information for trouble-free operation
 Install Testomat 2000
stress.
 Install Testomat 2000

Operating Testomat 2000

pressure range of 0.3 to 1 bar
Prior to installation, please check whether lower operating pressure is
required. The instrument is factory set for the operating range of 1 to

8 bar. Remove the flow controller valve body
instrument in the operating range of 0.3 to 1 bar (e.g. when using an

aerator type R). This involves removing the retaining pin
controller/filter receiver
 remove the controller plug
flow controller valve body
retaining pin.

Installing Testomat 2000

Select an installation site where the water inlet hose can be kept as
short as possible (max. 5 m).
 Please leave sufficient space on the left-hand side of the
instrument to open the door.
 Drill the mounting holes as shown in the drawing on the left.
 Use three screws to attach the instrument at a suitable position in
the switch cabinet or on a wall.
®
PO4 at a location where it is protected
®
PO4 vertically and without mechanical
®
PO4 at a vibration-free site.
®
PO4 in the


. Subsequently use the metal bracket to

from the borehole. Then remove the

and reinsert the controller plug and the
®
Installation
to operate the

from the
11