Installing The Fusionm Or Aqualink ® Rs Purelink Tm; Figure 7. Power Pack Installation - Nature2 Fusion soft Serie Manual De Instalación Y Operación

Page 16
7. Start the pump and allow water to pass through the newly plumbed system. Check for any leaks.
8. Make sure the fl ow rate to the Nature
3.7 Installing the FUSIONM or AquaLink
The power center is required to have the appropriate means of disconnection, circuit isolation, and/or branch circuit
protection installed upstream of the power center.
NOTE The control/power center should be located at or near the equipment pad.
1. Locate the control/power center at least fi ve (5) feet or more away from pool/spa and fi ve (5) feet off the ground.
All national, state, and local codes are applicable.
2. The control/power center comes with two (2) full length, heavy duty mounting brackets fastened to the back
of the power center during shipping. Remove the four (4) screws that are holding the two (2) brackets and the
cardboard shipping cover in place (see Figure 7). Remove and discard the cardboard.
3. Using the top mounting bracket as a guide, mark three (3) holes on the mounting surface where the power center
will be installed. Drill the holes in the mounting surface.
NOTE The three (3) mounting holes are 4" (10 cm) apart center to center.
NOTE Use heavy-weight screws. The power center with all available components installed weighs approximately 30
pounds.
4. Reinstall the mounting brackets to the top and bottom of the back of the control/power center using the four (4)
screws that were removed in Step 2. Ensure that the brackets are rotated from the original shipping position.
5. Hang the power pack on the surface using the three (3) holes drilled in Step 3. With the control/power center in
place, mark three (3) holes for the bottom bracket mounting.
NOTE As with the top brackets, the bottom bracket requires three (3) mounting holes. The three (3) mounting holes
are 4" (10 cm) apart center to center.
6. Drill the holes and install the screws.
Screws (4)
Figure 7. Power Pack Installation
Nature Fusion Soft Installation and Operation Manual
2®
2 Fusion Soft does not drop below 30 gpm (114 lmp).
®
4"
(10 cm)
(10 cm)
Mark holes on mounting surface
RS PureLink
TM
CAUTION
Mounting Brackets (2)
Control/Power Center
4"