5.5
Operating in Winter
See Section 6.7, Winterizing.
5.6
Recommendations
• DO List
•
Read and keep your manual in a safe place.
•
Replace the start-up cartridge within 30 days and again every six (6) months.
•
Increase chlorine production rate before a large number of bathers enter the pool and return to normal afterwards.
•
Increase chlorine production rate when temperature goes up.
•
Increase chlorine production rate when the number of bathers goes up.
•
For outdoor pools only, use stabilizer (cyanuric acid) to stabilize chlorine in pool.
•
Mount power center in shade or out of the direct sunlight whenever possible.
•
Decrease production rate when temperature goes down (for example, in the Fall and Winter seasons).
•
Take pool water sample to a qualifi ed service representative once per month.
• DON'T List
•
Do not get fertilizer in your pool. Fertilizers contain nitrates which cause a high chlorine demand on pool water.
•
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal dilution of pool
water with fresh water. A build up of by products can damage the electrolytic cell.
•
Do not add chemicals or salt to the pool unless the chlorinator is turned off.
•
For outdoor pools only, do not let chlorine stabilizer (cyanuric acid) drop below 10 ppm.
•
Do not add salt without fi rst checking the pool salinity level. Too much salt can disable and possibly damage the
chlorinator.
Nature
Fusion Soft Installation and Operation Manual
2®
Page 37